| Installation process for Windows 95.
The self extractor will extract KDS monitor drivers to
C:\KDS folder. Follow the procedure below:
1. Close all open applications.
2. From Windows the Windows desktop, click;
START
Settings
Control Panel
3. Click Display Properties
4. Click the Settings tab
5. Click Change Display Type or Advanced Properties
At this point you will need to know if you have Windows 95 REV A
or REV B. If you Revision A you will have a Tab called Change
Display Type if you have Revision B you will have Advanced
Properties.
For Revision A
**********************************
Click Change Display Type
Click Change on the MONITOR PART OF THE SCREEN (The lower Section)
Click on the Show all Devices button
Click Have Disk
Click Browse
Double Click on C:
Click c:\KDS
Click OK
Highlight KDS under Manufacturers from the List
Click on the Monitor that you have
Click OK
Click Close to exit display Properties
Click START
Click SHUTDOWN
Click RESTART
For Revision B
**********************************
Click on Advanced Properties
Click on the Monitor Tab
Click on Change
Click on the Show all Devices button
Click Have Disk
Click Browse
Double Click on C:
Click c:\KDS
Click OK
Highlight KDS under Manufacturers from the List
Click on the Monitor that you have
Click Apply
You will get a message "Windows will now Adjust the Refresh Rate.
If the screen becomes garbled wait 10 seconds and your original
setting will return.
Do You want to Keep these settings Say "YES"
Click OK
II. Windows 98
Drivers are at the top of the page
Installation process for Windows 98.
The self extractor will extract KDS monitor
drivers to
C:\KDS folder. Follow the procedure below:
1. Close all open applications.
2. From Windows the Windows desktop, click;
START
Settings
Control Panel
3. Click Display Properties
4. Click the Settings tab
5. Click Advanced Properties
6. Click on the Monitor Tab
NOTE:If you don't have a MONITOR tab, refer to ii.a.
section below.
7. Click on Change
8. Click on the Show all Hardware button
9. Click Have Disk
10. Click Browse
11. Double Click on C:
12. Click c:\KDS
13. Click OK
14. Highlight KDS under Manufacturers from the List
15. Click on the Monitor that you have
16. Click Apply
You will get a message "Windows will now Adjust the
Refresh Rate. If the screen becomes garbled wait 10
seconds and your original setting will return.
17. Do You want to Keep these settings Say "YES"
18. Click OK
19. Close
20. Done
II.a NO MONITOR TAB in Display Properties
==================================================
1. Close all programs
2. Click START
3. Click SETTINGS
4. Click CONTROL PANEL
5. Click SYSTEM
6. Click DEVICE MANAGER
7. Double click MONITOR. Current device will be displayed.
8. Highlight the device
9. Double-click device
10. You will get two tabs; GENERAL and DRIVER
11. Click on DRIVER
12. Click UPDATE DRIVER
13. Click NEXT
14. Click DISPLAY LIST OF ALL DRIVERS IN A SPECIFIC LOCATION
SO YOU CAN SELECT THE DRIVERS YOU WANT.
15. Click NEXT
16. Click HAVE DISK
17. Type C:\KDS over the default A:\
18. Click OK
19. Click OK
20. Click NEXT
21. Click NEXT
22. Click FINISH
|
